Assembly and Handling
Contact
Series
B1.852

Swing Clamps with Sturdy Swing Mechanism

Cartridge type, position monitoring optional
double acting, max. operating pressure 350 bar
Swing Clamps with Sturdy Swing Mechanism
Downloads
Catalogue sheet
Operating instructions
Information Series
Description
B 1.852 Swing Clamps with Sturdy Swing Mechanism

Hydraulic  swing  clamps  are  used  for  clamping of workpieces, when it is essential to keep the clamping area free of straps and clamping components  for  unrestricted workpiece loading and unloading.
This  series  obtains  very  high  clamping  forces already at 120 bar and can directly be connected  to  the  low-pressure  hydraulics  of  the  ma-
chine tool. An additional power unit for power workholding is no longer necessary.
With the sturdy swing mechanism and the optional position monitoring these swing clamps are particularly suitable for:

  • Automatic manufacturing systems with very short cycle times
  • Clamping fixtures with workpiece loading by handling systems
  • Transfer lines
  • Test systems for motors, gears and axes
  • Assembly lines
  • Special machine tools

 

The hydraulic swing clamp is a pull-type cylinder where a part of the total stroke is used to swing the piston.
Due to the sturdy swing mechanism the angle position of the clamping arm remains the same after a slight collision with the workpiece during loading and unloading or during clamping.
The angle position of the clamping arm is fixed with a dowel pin.
The FKM wiper at the piston rod can be protected against coarse and hot swarf by an optionally available metallic wiper.
The version with extended switch rod is provided for mounting of pneumatic or electrical position monitorings (accessory).

Version without bottom cover
Focusing on a short length, the bottom cover had been omitted. The piston contacts the bottom of the cartridge-type hole.

Accessories (27)
Item no. CAD data Description
Item no.
CAD data
Description
Clamping arm with contact bolt for series 1844 max. 350 bar, as per data sheet B1.852
Item no.
CAD data
Description
Clamping arm with contact bolt for series 1845 max. 350 bar, as per data sheet B1.852
Item no.
CAD data
Description
Clamping arm with contact bolt for series 1846 max. 350 bar, as per data sheet B1.852
Item no.
CAD data
Description
Clamping arm with angle bracket for series 1843 max. 350 bar, as per data sheet B1.852
Item no.
CAD data
Description
Clamping arm with angle bracket for series 1844 max. 350 bar, as per data sheet B1.852
Item no.
CAD data
Description
Clamping arm with angle bracket for series 1845 max. 350 bar, as per data sheet B1.852
Item no.
CAD data
Description
Clamping arm with angle bracket for series 1846 max. 350 bar, as per data sheet B1.852
Item no.
CAD data
/
Description
Index pin Ø3 x 6 mm, St50k as per data sheet B1.852
Item no.
CAD data
Description
Nut M18 x 1.5 mm as per data sheet B1.880
Item no.
CAD data
Description
Nut M28 x 1.5 mm as per data sheet B1.880
Loading…